Nortel Networks Installing Media Dependent Adapters Manual de usuario descargar pdf (Pagina 39)

6. Attach devices to the MDA ports.

Refer to your switch’s User Guide for instructions on

attaching devices to the MDA ports. After connecting

the port cables, follow the instructions to connect

power and verify the installation.

Replacing an MDA

When replacing an installed MDA:

1. Power down the switch (or unplug the Passport

8132 module from the switch backplane).

2. Remove the installed MDA.

Loosen the two thumbscrews on the MDA front panel

to remove the MDA.

3. Install the replacement MDA.

Be sure to firmly tighten the two thumbscrews on the

MDA front panel.

4. Power up the switch.

5. Attach devices to the MDA ports.

Refer to your switch’s User Guide for instructions on

attaching devices to the MDA ports.

Note:

The IEEE 802.3u specification requires that all

ports operating at 100 Mb/s use only Category 5

unshielded twisted pair (UTP) cabling.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44

Sin comentarios

Nortel Networks Installing Media Dependent Adapters Manual de usuario Pagina 39