Nortel Networks 40M2420 Manual de usuario descargar pdf (Pagina 172)

Alteon OS Command Reference

172

 Chapter 6: The Configuration Menu 40M2420, April 2007

Viewing, Applying, and Saving Changes

As you use the configuration menus to set switch parameters, the changes you make do not

take effect immediately. All changes are considered “pending” until you explicitly apply them.

Also, any changes are lost the next time the switch boots unless the changes are explicitly

saved.

NOTE – Some operations can override the settings in the Configuration menu. Therefore, set-

tings you view in the Configuration menu (for example, port status) might differ from run-time

information that you view in the Information menu or on the management module. The Infor-

mation menu displays current run-time information of switch parameters.

While configuration changes are in the pending state, you can do the following:

 View the pending changes

 Apply the pending changes

 Save the changes to flash memory

Viewing Pending Changes

You can view all pending configuration changes by entering diff at the menu prompt.

NOTE – The diff command is a global command. Therefore, you can enter diff at any

prompt in the CLI.

Applying Pending Changes

To make your configuration changes active, you must apply them. To apply configuration

changes, enter

apply at any prompt in the CLI.

NOTE – The apply command is a global command. Therefore, you can enter apply at any

prompt in the administrative interface.

# apply

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 381 382

Sin comentarios

Nortel Networks 40M2420 Manual de usuario Pagina 172