Nortel Networks Remote Gateway 50 Manual de usuario Pagina 175

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 260
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 174
Dialing Plan configuration Page 175 of 258
Main Office Configuration for Survivable Remote Gateway 50 Configuration Guide
At the branch office (see Procedure 13 on page 187):
1 Configure the Route List Index.
2 Configure ESN.
These steps can be done using overlays, as described in this section, or in
Element Manager and NRS Manager. Refer to IP Peer Networking:
Installation and Configuration (553-3001-213) for more details. For
information on configuring the dialing plan at the branch office, refer to
SRG50 Configuration Guide.
Procedure 11
Configuring the main office
1 Configure the ZACB property for the branch office zone.
The ZACB and ZDP properties are used to configure the digit
manipulation behavior of the branch office zone (see step 2 on
page 177).
The ZACB property specifies which calls undergo digit manipulation.
The attribute can be configured in the following ways:
CHG ZACB <zone>
In this configuration, dialing AC1 or AC2 does not trigger digit
manipulation. SRG users’ calls are treated exactly the same as
those for main office users.
CHG ZACB <zone> ALL
In this configuration, calls dialed with AC1 and calls dialed with
AC2 undergo zone-based digit manipulation. All SRG users’
calls can then be routed to the SRG PSTN.
LD 117 – Define the zone Access Code handling for the branch office zone.
Command Description
CHG ZACB <zone> [ALL]|[<AC1|AC2> <AC1|AC2>]
Define the Access Codes used to modify local or long-distance
calls in the branch office to force all branch office calls to be
routed to the MG 1000B PSTN.
Vista de pagina 174
1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 259 260

Comentarios a estos manuales

Sin comentarios