Nortel Networks Remote Gateway 50 Manual de usuario Pagina 183

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 260
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 182
Dialing Plan configuration Page 183 of 258
Main Office Configuration for Survivable Remote Gateway 50 Configuration Guide
ESN Special Numbers are configured in LD 90. Respond to the
prompts as follows:
• TRAN — Enter the Access Code.
• TYPE — Enter SPN for this configuration, as the ZDP value
configured in step 3 on page 178 is usually a unique non-dialable
number.
• SPN — Enter the ZDP value plus enough digits to distinguish the
type of number, such as national, international, or local. There must
be enough SPN entries to route all valid dialed numbers (see the
example in this section).
• FLEN — Enter the number of digits that are expected for the call
type.
• RLI — Enter the RLI configured in LD 86 in step b on page 189.
The RLI routes the call to the NRS with the correct type of number.
• CLTP — Enter the type of call defined by this Special Number:
local (LOCL), national (NATL), or international (INTL).
For example, assume the following:
• AC1 = 1, ZACB = AC1 AC1, and ZDP = 101
• Customer number = 0
• Long-distance calls start with “1”, have 11 digits, and use
RLI = 10 and DMI = 10.
• Local calls start with “5” or “6”, are seven digits long, and use
RLI = 30 and DMI = 30.
Note: RLI and DMI values do not have to be the same, but for clarity, it
may be useful to set them the same.
>LD 90
REQ NEW
CUST 0
FEAT NET
TRAN AC1
TYPE SPN
SPN 1011
FLEN 14 11 digits for long-distance + 3 digits for ZDP
...
RLI 10
Vista de pagina 182
1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 259 260

Comentarios a estos manuales

Sin comentarios