Nortel Networks Remote Gateway 50 Manual de usuario Pagina 83

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 260
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 82
Bandwidth Management Page 83 of 258
Main Office Configuration for Survivable Remote Gateway 50 Configuration Guide
CHG ZQRTI <Zone> <Interval>
Change the QoS Response Time Interval while alarms are not coming, in
order to increase the Sliding Maximum for the identified zone, where:
Zone = 1-255
Interval = interval in minutes = 1-(5)-120
CHG ZQUAT <Zone> <Thres>
Change the QoS Unacceptable Alarm Threshold value for the identified zone,
where:
Zone = 1-255
Thres = threshold value = 1-(75)-99
Note: When the zone-to-zone QoS value drops below the threshold value,
the alarm is presented. When the zone-to-zone QoS value is greater than this
threshold value, this alarm is presented as being deactivated. This value must
be below the value of ZQWAT.
CHG ZQWAT <Zone> <Thres>
Change the QoS Warning Alarm Threshold value for the identified zone,
where:
Zone = 1-255
Thres = threshold value = 1-(85)-99
Note: When the zone-to-zone QoS value drops below the threshold value,
the alarm is presented. When the zone-to-zone QoS value is greater than this
threshold value, this alarm is presented as being deactivated. The value for
ZQWAT must be higher than the value of ZQUAT.
LD 117 — Configure Adaptive Network Bandwidth Management. (Part 4 of 6)
Command Description
Vista de pagina 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 259 260

Comentarios a estos manuales

Sin comentarios