Nortel Networks CALLPILOT 555-7101-226 Manual de usuario descargar pdf (Pagina 59)

November 2005 Installing the server and connecting the peripheral devices

Part 2: 703t Server Hardware Installation 59

Connecting the server to the CLAN

(optional)

Introduction

This section provides instructions to connect the server to the Customer

LAN (CLAN).

Note: The CLAN connection is optional. However, connection to a CLAN

is required for support of desktop and web messaging users, or

administration by means of a web-enabled PC.

To connect the server to the CLAN

1 Locate the CLAN connector on the back of the server.

Note: The CLAN connector is labeled as NIC2 1GB. For the connector

location, see the diagram on page 54.

2 Connect an RJ-45 network cable from the CLAN hub to the CLAN

connector.

What’s next?

Continue with “Installing the Nortel Networks software feature key adapter”

on page 60.

ATTENTION

If a hub is required or used, it must be located at least 6 m

(20 ft) away from the 703t server. This ensures compliance

with EMC requirements.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 71 72

Sin comentarios

Nortel Networks CALLPILOT 555-7101-226 Manual de usuario Pagina 59