Nortel Networks 1000M Manual de usuario Pagina 134
- Pagina / 458
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Page 134 of 456 Planning and designating a Main Distribution Frame
NN43021-310 Standard 02.01 December 2007
This chapter describes how to install and connect a CS 1000M system using
the BIX or Krone Test Jack Frame (UK) cross-connect terminals.
Note: The examples shown here are BIX and Krone cross-connect
systems. These items are commercially available, but are not supplied by
Nortel.
This chapter contains the following procedures:
• Procedure 11: “Installing the BIX cross-connect terminal” on page 135.
• Procedure 12: “Installing the Krone Test Jack Frame (UK)” on page 138.
Terminal block requirements
The cross-connect terminal requires enough connecting blocks to terminate:
• up to 16 25-pair cables for each IPE shelf
• up to four 25-pair cables for each Media Gateway and Media Gateway
Expander
• four conductors for the AUX cable from the Media Gateway
• one 25-pair cable from each PFTU
• wiring from telephones and trunks.
Installing the BIX cross-connect terminal
Procedure 11 describes how to install the BIX cross-connect terminal.
DANGER
Always use caution when installing or modifying
telephone lines. Do not install telephone wiring during a
lightning storm. Never touch uninsulated telephone
wiring, unless the line is disconnected at the network
interface.
- Meridian 1 1
- Page 4 of 456 Contents 4
- Page 8 of 456 Contents 8
- Contents Page 9 of 456 9
- Page 10 of 456 Contents 10
- New in this release 11
- List of Procedures 13
- How to get help 19
- Finding the latest updates 21
- System information 23
- Applicable systems 24
- Intended audience 25
- Conventions 26
- NTP feedback 26
- Related information 27
- Introduction 31
- Page 32 of 456 Introduction 32
- Summary of procedures 33
- Page 34 of 456 Introduction 34
- Page 36 of 456 Introduction 36
- Preparing for installation 37
- System equipment – UEMs 38
- Figure 1 39
- Universal Equipment Modules 39
- Columns are grouped in rows 40
- Figure 2 41
- Card cage 42
- Figure 4 44
- System options 45
- Main column 46
- Core/Net 0 46
- Core/Net 1 46
- Figure 7 47
- Four-tier multi-group system 47
- Figure 8 48
- Figure 9 50
- Signaling Server 52
- Business Policy 53
- Signaling 53
- 553-AAA0561 53
- Cable routing guidelines 54
- Cabling troughs 55
- 553-3117 55
- Figure 13 56
- Unloading equipment 58
- Working with power supplies 59
- Handling circuit cards 59
- Figure 16 60
- Static discharge points 60
- 553-A0132 63
- Turn lock screw 63
- Slide to 63
- 553-3054 64
- Captive screw 64
- Overview 65
- Figure 19 67
- Module positioning guides 67
- 553-5068 69
- Screw Stand-off 74
- 553-5067 75
- Installing AC power 77
- Large System 79
- Ground lugs 83
- 553-8996 84
- Installing UPS ground cabling 85
- 553-3089 87
- Bolt for bracket 91
- Customer-provided 91
- Installing DC power 93
- Candeo DC power systems 94
- Large Candeo modules 97
- Small Candeo modules 101
- Figure 35 104
- Installation reference guide 106
- Configuration reference guide 108
- (or safety ground) leads 111
- 553-AAA1515 114
- 553-AAA0759 115
- Figure 39 116
- Four-Feed PDU 117
- Cable-tie saddle 117
- Cable restraint bar 117
- 553-AAA0467 117
- 553-AAA0468 118
- Figure 42 119
- PDU circuit protection 119
- BLO CB0 CB1 121
- J6J5J3 J4 121
- 553-8997 121
- Installing the Four-Feed PDU 123
- 553-8995 124
- 553-AAA0760 128
- System monitor connections 130
- Each output is rated at 30 A 131
- Planning and designating a 133
- Main Distribution Frame 133
- Terminal block requirements 134
- Figure 49 136
- BIX module 136
- Figure 50 137
- 553-6459 139
- 553-6460 140
- 553-6461 141
- 553-6463 142
- 553-6465 143
- EXCHANGE LINES 144
- EXCHANGE LINES 144
- Contents 145
- PFTU configurations 145
- Figure 60 146
- 553-7559 147
- Installing a PFTU 148
- Installing QUA6 PFTUs 150
- System monitor cabling 151
- AC power control 152
- DC power observation 152
- Cabling the System Monitor 157
- 553-7544 158
- 553-3112 159
- 553-3111 160
- Slave unit n 161
- UPS for each column 164
- J4 on system monitor 164
- UPS alarm cable 164
- Large System columns 164
- Alarm interfacing to Candeo 165
- Configuring the alarm ports 168
- Customizing alarms 169
- About the system terminal 171
- 553-A0131 172
- Connecting a terminal 173
- COM1 and COM2 ports 175
- 553-A0134 176
- SDI and COM1 ports 177
- Connecting a modem 178
- Modem guidelines 179
- Configuring a modem 180
- (see Figure 72 on page 183) 181
- Remote end 183
- Figure 73 185
- Figure 74 186
- Cabling Common Equipment in a 187
- Single Group system 187
- Core/Net module 189
- Figure 76 190
- Figure 77 191
- Reviewing required Core cards 192
- Cabling the Core side 193
- 553-9059 194
- Cabling the I/O panel 195
- Cabling the Network side 197
- PS 01234567891011 198
- NT8D80AZ cable 201
- Network backplane 202
- Core backplane 202
- Sys Util 203
- I/O Panel 205
- (rear of module) 205
- Core shelf (front of module) 205
- Rear of module 206
- Front of module 206
- Multi Group system 207
- Figure 87 211
- Core shelf cabling 216
- Required Core cables 217
- Figure 91 220
- Figure 92 222
- I/O panel connections 222
- End of Procedure 222
- Figure 93 224
- Options for LAN 1 connections 224
- Figure 94 225
- Dual Ring Fiber Network 225
- Required cards 226
- Required cables 226
- FIJI card cabling 228
- Figure 95 229
- FIJI card faceplate 229
- Figure 96 230
- Shelf 0 fiber optic ring 232
- Shelf 1 fiber optic ring 233
- FIJI to FIJI cabling 234
- FIJI FIJI 236
- Figure 101 238
- Network-to-network cabling 239
- Network module connections 240
- Figure 103 242
- Network backplane: 244
- NT8D99AB cable 244
- 553-9488 245
- IGS/FIJI card 245
- NT8D76 cables 245
- (factory installed) 245
- Figure 106 246
- 553-9529 247
- Install SDI Paddle Board 247
- NTND14 to 3PE cables 247
- Figure 108 249
- Figure 109 250
- Figure 110 255
- 553-5289 258
- Figure 112 259
- Figure 113 260
- Cabling lines and trunks 261
- 553-5391 262
- Network Voltages (TNV) 263
- Figure 115 265
- NT8D37 IPE Module I/O panels 265
- Connecting lines and trunks 266
- Powering up the system and 299
- Figure 116 301
- Security Device 301
- Preparing to power up – AC 302
- Turning AC power ON 303
- Preparing to power up – DC 306
- Turning DC power ON 306
- IMPORTANT! 307
- Installing software 308
- Switch call processing 332
- Performing acceptance tests 335
- Testing the sysload 339
- Testing the PFTU 341
- Installing earthquake bracing 343
- Installing seismic bracing 344
- Selecting the kit 345
- Drilling concrete floors 347
- Figure 118 350
- Mounting plate installation 350
- Installing earthquake rods 351
- Air exhaust grill 352
- 553-3038 353
- 553-3063 355
- FrontRear 356
- Gasket placement 356
- 553-5641 356
- — 28mm (11/8in.) for Kit A 357
- — 24 mm (15/16 in.) for Kit B 357
- 553-7473 361
- Adding a module to a column 363
- Power plug (J1) 366
- System monitor connector 366
- (NT8D46CB cable) 366
- Mounting 367
- 553-3057 367
- Figure 127 369
- DANGER OF ELECTRIC SHOCK 370
- Positioning guides 372
- Opening for 372
- Orange connector 375
- Push here 375
- 1/4 turn fasteners 376
- Figure 133 377
- Top cap assembly 377
- Figure 136 380
- Key on cable 381
- Installing a Signaling Server 383
- Readiness checklist 385
- Connections 389
- Figure 139 391
- Before you begin 399
- Installing the software 400
- Commissioning (NN43001-313) 427
- (NN43001-313) 432
- Numerics 449
- Page 456 of 456 Index 456
- Communication Server 1000M 458
Relacionado con productos y manuales para Redes Nortel Networks 1000M
Redes Nortel Networks 10BASE-T Manual de usuario
(330 paginas)
(330 paginas)
Redes Nortel Networks NN43001-321 Manual de usuario
(110 paginas)
(110 paginas)
Redes Nortel Networks 24T Manual de usuario
(310 paginas)
(310 paginas)
Redes Nortel Networks 400-S Manual de usuario
(86 paginas)
(86 paginas)
Redes Nortel Networks 5100 Manual de usuario
(160 paginas)
(160 paginas)
Redes Nortel Networks NN47200-503 Manual de usuario
(318 paginas)
(318 paginas)
Redes Nortel Networks NN46110-602 Manual de usuario
(230 paginas)
(230 paginas)
Redes Nortel Networks CVX 600 Manual de usuario
(168 paginas)
(168 paginas)
Redes Nortel Networks 553-3901-200 Manual de usuario
(48 paginas)
(48 paginas)
Redes Nortel Networks WEB OS 212777 Manual de usuario
(482 paginas)
(482 paginas)
Redes Nortel Networks NN43001-301 Manual de usuario
(306 paginas)
(306 paginas)
Redes Nortel Networks NN43001-314 Manual de usuario
(418 paginas)
(418 paginas)
Redes Nortel Networks 553-3001-358 Manual de usuario
(244 paginas)
(244 paginas)
Redes Nortel Networks NN44200-313 Manual de usuario
(66 paginas)
(66 paginas)
Redes Nortel Networks HotWire 8600 Manual de usuario
(62 paginas)
(62 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.046 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales