Nortel Networks 8672ATME Manual de usuario descargar pdf (Pagina 137)

Chapter 6 Configuring the Passport 8672ATME Module 137

Using the Passport 8672ATME Module

2 To add an ATM port (in this example, 1/1) and several Ethernet ports (in this

example, 3/40 to 3/48) to the VLAN, enter:

config vlan 2 port add 1/1

config vlan 3 port add 3/40-3/48

3 To configure IP addresses on both VLANs (use two different subnets), enter:

config vlan 2 ip <

ip address

>/<

subnet mask

config vlan 3 ip <

ip address

>/<

subnet mask

4 To enable routing on both VLANs, enter:

config vlan 2 ip rip enable

config vlan 3 ip rip enable

If necessary, use the following CLI commands to change RIP parameters:

config vlan 2 ip rip <

sub-command

config ip rip <

sub-command

5 To configure an ATM 1483 PVC with LLC/SNAP-encapsulation and UBR,

enter:

config atm 1/1 pvc create 0.100 enc 1483-llc serv

ubr

6 To associate the 1483 IP routed PVC with a VLAN, enter:

config atm 1/1 pvc 1483 ip create 2 0.100 <r

emote

side IP address

The remote IP address should be in the same subnet with the ATM port IP

address.

Configuring an IPX routing 1483 PVC using Device Manager

In the configuration shown in Figure 60, the Passport 8672ATME Module has an

ATM 1483 PVC as the sole member of a VLAN configured for IPX routing.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 161 162

Sin comentarios

Nortel Networks 8672ATME Manual de usuario Pagina 137