Nortel Networks 8672ATME Manual de usuario Pagina 80

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 162
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 79
80 Chapter 5 Managing the Passport 8672ATME Module with the CLI
209195-B
config atm command
Table 17 describes the parameters and variables for the config atm <
ports
>
command.
Table 17 config atm command parameters and variables
Parameters and variables Description
action <action choice> Flushes a MAC, ARP, or IP table or triggers a RIP update. Choices are:
none
flushMacFdb
flushArp
•flushIp
flushAll
triggerRipUpdate
number-vpi-bits <number-vpi-bits> Sets the number of bits used to represent VPI. Enter integer from 0
to 8.
For OC-3c, 11 bits split between NumVpiBits and NumVciBits.
NumVpiBits cannot exceed 6 bits for OC-3c.
For OC-12c, 13 bits split between NumVpiBits (default is 4) and
NumVciBits (default is 9). NumVpiBits cannot exceed 8 bits for
OC-12c.
scrambling <enable | disable> Enables or disables scrambling.
framing-mode <sonet | sdh> Sets the framing to:
sonet (Synchronous Optical Network), the standard format used in
North America.
sdh ( Synchronous Digital Hierarchy), the standard format used
worldwide except in North America.
clock-source <loop-timed |
free-running>
Sets the transmit clock source to:
loop-timed, which means clocking is derived from line.
free-running, which means clocking is derived from on-board clock.
Note that if you have two connected
Passport 8672ATME Modules,
you must set both to free-running or one to loop-timed and one to
free-running; do not set both to loop-timed.
loop-back-mode <off | internal |
remote>
Sets the loopback mode to:
•off
internal
external
Vista de pagina 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 161 162

Comentarios a estos manuales

Sin comentarios