Nortel-networks NN43001-563 Manual de usuario Pagina 310

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 490
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 309
310 Provisioning IP Trunk 3.01 (and later) in TM 3.1
17
Click the Ports tab. See Figure 100 "New ITG Node Ports tab"
(page 310).
Figure 100
New ITG Node Ports tab
18 This tab is only present for IP Trunk 3.01 (and later) nodes. Use
the drop-down list to select the RTP port starting value. There are
two options, as follows:
2300 default value
17300 used for Cisco RTP header compression
Alternatively, enter any even-numbered port starting value between
1024 and 65534.
WARNING
Entering a starting port value other than 2300 or 17300
does not block calls, but can result in unexpected behavior,
as certain port ranges are reserved by the IETF.
Cisco header compression can be used only if a starting
port value is entered that is equal to or greater than 17300.
Click the Restore Default button to restore the default port start
value.
Add the node
19
Click OK to complete the node provisioning. The ITG Node
Properties window closes. The node data is now displayed in the
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.
Vista de pagina 309
1 2 ... 305 306 307 308 309 310 311 312 313 314 315 ... 489 490

Comentarios a estos manuales

Sin comentarios