Nortel-networks Sun Fire V100 Manual de usuario descargar pdf (Pagina 163)

MCS 4-server Sun Fire V100 Solaris Installation and Commissioning Guide

163

6 Click Apply.

Note: Wait for the component to appear in the server list.

7 Enter a label (maximum six [6] characters) in the Service

Component Name field at the bottom of the dialog box that

appears.

Example : H323GK

Note: The parameters with asterisks (*) are mandatory. The

grayed-out fields are for information only and cannot be

changed.

Procedure 46 Configuring the services

At the System Management Console,

1 The installer must enter data into the all tabs and fields shown in

Ta bl e 4 2, H225 Signaling Address tab through Table 46, SIP

TCF Base tab.

Note: If you need to install a redundant gatekeeper, also fill in

the Transport Management and Server Properties tabs and

then blank out the signaling addresses and transport config

fields shown in Table 42, H225 Signaling Address tab,

Ta bl e 4 3, H245 Signaling Address tab, Table 44, H.323

Gatekeeper tab, and Tabl e 4 6 , SIP TCF Base tab. For

complete information about the Transport Management and

Server Properties tabs, see the MCS 5100 H.323 Gatekeeper

Basics (NN10280-111) document.

ATTENTION

Do not click on Apply until you have finished filling in the fields

that you need.

Table 42 H225 Signaling Address tab

Parameter Recommended value Notes Example

H225 Signaling

Address

TCP=0.0.0.0:1720:selectbased This field

contains the

address and port

for H.225

signaling. The

TCP port must

be 1720.

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 191 192

Sin comentarios

Nortel-networks Sun Fire V100 Manual de usuario Pagina 163