Nortel Networks 8672ATME Manual de usuario Pagina 111
- Pagina / 162
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 5 Managing the Passport 8672ATME Module with the CLI 111
Using the Passport 8672ATME Module
Configuring ATM F5-OAM End-to-End Loopback
A Passport 8672ATME Module, by default, replies to ATM F5-OAM Loopback
requests received. However, the transmission of F5-OAM Loopback requests and
the processing of F5-OAM Loopback replies received require enabling this
feature on a PVC by PVC basis. It is recommended that you enable ATM
F5-OAM on all the PVCs configured on the PP8672 ATM port in order for upper
layer protocols such as MLT and OSPF to be immediately aware of the port down
status or link failures.
You can enable and define the parameters of the ATM F5-OAM Loopback feature
and display statistics with Device Manager or the CLI. For information on how to
configure this feature with the Device Manager, see Chapter 4, “Managing the
Passport 8672ATME Module with Device Manager,” on page 47.
The F5-OAM loopback feature uses the following CLI commands:
•
config atm pvc f5-oam command
• show ports info atm pvc [slot/port]
• show ports info atm f5-oam [slot/port]
• clear atm f5-oam [slot/port]
TIME ELAPSED Number of seconds, including partial seconds, that have
elapsed since the beginning of the current measurement
period. If the current interval exceeds the maximum value,
the agent will return the maximum value.
VALID INTERVALS Number of previous 15-minute intervals for which data was
collected.
LINE CODING Line coding for this interface. The B3ZS and CMI are used
for electrical SONET/SDH signals (STS-1 and STS-3). The
Non-Return to Zero (NZR) and the Return to Zero are used
for optical SONET/SDH signals.
LINE TYPE Line type for this interface. The line types are Single Mode
fiber or Multi-Mode fiber interfaces.
CIRCUIT ID Transmission vendor’s circuit identifier, to facilitate
troubleshooting.
Table 38 Information fields for output of the show ports stats atm
sonetmediumtbl command (continued)
Field Description
- Using the Passport 8672ATME 1
- Trademarks 2
- Statement of conditions 2
- USA requirements only 2
- European requirements only 2
- Taiwan requirements 3
- Canada requirements only 3
- Contents 7
- Chapter 6 10
- 12 Contents 12
- 16 Figures 16
- Before you begin 19
- Text conventions 20
- Related publications 21
- 22 Preface 22
- Preface 23 23
- How to get help 24
- Chapter 1 25
- Features 26
- ATM ELANs, and Ethernet VLANs 27
- Virtual network router 27
- Traffic shaping 27
- Physical description 28
- Media dependent adapters 29
- Online LED 30
- MDA LEDs 31
- Console and Diag ports 32
- Chapter 2 33
- SONET terms and acronyms 35
- SONET transmission rates 36
- Chapter 3 37
- Verifying installation 41
- Initialization 42
- Replacing a module 45
- Chapter 4 47
- Installing Device Manager 49
- Configuring and managing ATM 51
- Changing default settings 52
- Resetting the module 54
- Figure 13 Card tab 55
- Table 6 Card tab fields 55
- Viewing MDA information 56
- Enabling or disabling a port 57
- Editing port parameters 58
- Figure 16 ATM tab 59
- Table 8 ATM tab fields 59
- Editing circuit parameters 60
- Figure 17 ATM PVC tab 61
- 4 Click Insert 62
- Deleting a PVC 63
- Figure 20 ATM 1483 ELAN tab 64
- Deleting an ATM 1483 ELAN 69
- 2 Highlight a PVC 71
- 3 Click F5 Loopback 71
- (Figure 26) 71
- Testing using Device Manager 73
- Chapter 5 75
- Configuration commands 76
- Module commands 76
- 1483 ELAN statistics 77
- Port commands 79
- Passport 8672ATME Modules 80
- 1483 ip command 83
- 1483 ipx command 83
- Show commands 85
- Figure 30 86
- 1483 command 93
- command 100
- [slot/port] 114
- Port Stats Interface 116
- 209195-B 118
- Device Manager 120
- Figure 51 Basic tab 121
- 2 Click Insert 122
- Configuring an ATM 1483 PVC 125
- Creating two VLANs “byPort” 130
- Assigning IP addresses 130
- Enabling RIP routing 132
- 4 Click the RIP tab 133
- Enabling OSPF routing 134
- Figure 59 OSPF tab 135
- Table 48 OSPF tab fields 135
- Field Description 139
- Encap Encapsulation format 139
- Enabling IPX forwarding 140
- Figure 64 Circuits tab 141
- Table 51 Globals tab item 141
- Chapter 7 145
- Web Management 145
- Passport 8672ATME Module 146
- (Figure 66) 147
- 148 Chapter 7 Web Management 148
- Figure 67 PVC page 148
- Table 54 PVC page items 148
- Chapter 7 Web Management 149 149
- 1483 ELAN page items 150
- Chapter 7 Web Management 151 151
- Figure 70 Port page 151
- Table 56 Port page items 151
- Passport 8672ATME 152
- Appendix A 153
- Technical Specifications 153
- Appendix B 155
- Factory defaults 155
© 2020, manymanuals.es. Todos los derechos reservados | 0.043 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales