Nortel Networks 10BASE-T Manual de usuario descargar pdf (Pagina 135)

Installing the BayStack 410-24T Switch

309985-C Rev 00

2-17

Initial Setup

The BayStack 410-24T switch is designed for “plug-and-play” operation; in most

cases the switch can be installed and made operational using the system default

settings (see Appendix E, “

Default Settings,” for a list of default settings for the

BayStack 410-24T switch).

However, for the switch management function to become fully operational, certain

parameters must be configured. A minimal configuration is required when you

plan on remote management or TFTP operations.

If you are configuring your BayStack 410-24T switches into a stack configuration,

you will need to supply additional parameters to properly setup the stack.

This section includes the following information:

• Instructions for the initial (standalone) switch setup

• Instructions for the initial stack setup

After setting up your switch or stack configuration as described in the following

sections, proceed to Chapter 3, “

Using the Console Interface,” for detailed

descriptions of the menus and screens you can use to customize your

configuration.

Standalone Switch Setup

For the initial setup of a standalone switch, you need to enter the IP address of the

switch, the subnet mask, and the gateway address (refer to Chapter 3, “

Using the

Console Interface,” for more information about configuring your BayStack

410-24T switch).

To set the IP address, subnet mask, and gateway address for the switch:

Apply power to the switch.

After the Nortel Networks logo screen appears, press [Ctrl]-Y.

The Main Menu is displayed (Figure 2-13

). The Main Menu hierarchy is

described in Chapter 3, “

Using the Console Interface.”

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 329 330

Sin comentarios

Nortel Networks 10BASE-T Manual de usuario Pagina 135