Nortel Networks 10BASE-T Manual de usuario descargar pdf (Pagina 94)

Using the BayStack 410-24T 10BASE-T Switch

1-64

309985-C Rev 00

Each of the trunks shown in Figure 1-39 can be configured with up to four switch

ports to provide maximum aggregate bandwidth through each trunk, in full-duplex

mode. As shown in this example, when traffic between switch-to-switch

connections approaches single port bandwidth limitations, creating a MultiLink

Trunk can supply the additional bandwidth required to improve the performance.

Figure 1-40

shows a typical switch-to-server trunk configuration. In this example,

file server FS1 uses dual MAC addresses, using one MAC address for each

network interface controller (NIC). For this reason, FS1 does not require a trunk

assignment. FS2 is a single MAC server (with a four-port NIC) and is set up as

trunk configuration T1.

Figure 1-40. Switch-to-Server Trunk Configuration Example

Client/Server Configuration Using MultiLink Trunks

Figure 1-41 shows an example of how MultiLink Trunking can be used in a

client/server configuration. In this example, both servers are connected directly to

switch S1. FS2 is connected through a trunk configuration (T1). The

switch-to-switch connections are through trunks (T2, T3, T4, and T5).

FS1

FS2

BS41032A

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 329 330

Sin comentarios

Nortel Networks 10BASE-T Manual de usuario Pagina 94