Nortel Networks 10BASE-T Manual de usuario Pagina 232
- Pagina / 330
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Using the BayStack 410-24T 10BASE-T Switch
3-90
309985-C Rev 00
Port A1 MAC
Address
Read-only field that indicates the port A1 MAC address of the ATM MDA that is
currently selected.
Port A2 MAC
Address
Read-only field that indicates the port A2 MAC address of the ATM MDA that is
currently selected.
LEC Fail Over
Allows you to enable or disable the LEC Fail Over feature.
Note:
The BayStack 450-2M3/2S3 MDA has two physical ports (A1 and A2) that are
available for LEC association. When the LEC Fail Over field value is set to Enabled,
the LEC(s) associated with a failed physical port is automatically assigned to the
remaining operational physical port. If the failed physical port recovers, the LEC(s)
will be automatically assigned to the desired port.
Default Disabled
Range Disabled, Enabled
LECS Address
Method
Allows you to configure the selected LEC to obtain LANE services from a LAN
emulation configuration server (LECS). You can choose one of three addressing
methods that the LEC will use (see Range field).
• ATM Forum -- The LEC will use an ATM Forum address.
• User Defined -- The LEC will use the User Defined Address value (see next field)
as the address of the LECS when attempting to set up the control direct to the
LECS.
• ILMI -- The switch will use the ILMI (interim local management interface) to obtain
the address of the LECS.
Default ATM Forum
Range ATM Forum, User Defined, ILMI
User Defined
Address
Allows you to specify the ATM user-defined address to be used in the LECS Address
Method field (see previous field). This field is a 20-byte ATM address
Default 39-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
Range Any 20-byte address field, where the first byte must be either 39,
45, or 47.
UNI Version
Allows you to select the user-to-network interface (UNI) the LEC will use. For more
information about UNI 3.0 and UNI 3.1, refer to
ATM User-Network Interface (UNI)
Specification, Version 3.0
and
ATM User-Network Interface (UNI) Specification,
Version 3.1
.
Default 3.1
Range 3.1, 3.0
(continued)
Table 3-33. ATM MDA Configuration Screen Fields
(continued)
Field Description
- Using the BayStack 410-24T 1
- 10BASE-T Switch 1
- Trademarks 2
- Statement of Conditions 2
- USA Requirements Only 2
- European Requirements Only 2
- Taiwan Requirements 3
- Canada Requirements Only 3
- Contents 7
- 309985-C Rev 00 10
- Audience 24
- Organization 24
- Text Conventions 25
- Acronyms 26
- Related Publications 28
- How to Get Help 29
- Chapter 1 31
- Front Panel 32
- 410-24T Switch 34
- Back Panel 36
- Features 39
- Security 43
- IEEE 802.1p 46
- IGMP Snooping Feature 47
- Flash Memory Storage 47
- Configuration Parameters 48
- MultiLink Trunking 49
- IEEE 802.1Q VLANs 49
- Port Mirroring 49
- SNMP MIB Support 51
- SNMP Trap Support 51
- Network Configuration 52
- Segment Switch Application 54
- CPU PS1 PS2FAN 55
- Fail-Safe Stack Application 56
- Stack Operation 57
- Cascade A Out 59
- Cascade A In 59
- Unit Select 59
- Cascade A InUnit Select 60
- Base Unit 61
- Stack Configurations 63
- IEEE 802.1Q VLAN Workgroups 68
- IEEE 802.1Q Tagging 69
- Shared Servers 76
- (Port Name is 80
- VLAN Workgroup Summary 81
- VLAN Configuration Rules 83
- IGMP Snooping 84
- IEEE 802.1p Prioritizing 89
- MultiLink Trunks 93
- Before Configuring Trunks 105
- 400-4FX MDA 107
- Chapter 2 119
- Figure 2-1. Package Contents 120
- Installation Procedure 121
- Caution: 122
- Comm Port 129
- Connecting Power 130
- Cascade Module 131
- 100-240V 131
- 47-63Hz~ 131
- Redundant Power 131
- Verifying the Installation 132
- Initial Setup 135
- Stack Setup 138
- Chapter 3 143
- Using the Console Interface 143
- Main Menu 146
- IP Configuration/Setup 150
- Choosing a BootP Request Mode 152
- BootP Disabled 153
- BootP or Last Address 153
- BootP When Needed 154
- BootP Always 154
- SNMP Configuration 155
- System Characteristics 157
- Switch Configuration 160
- MAC Address Table 163
- MAC Address-Based Security 165
- and 3-11) 170
- Configuration screen 171
- Screen 1 174
- Screen 2 174
- Screen 3 174
- Screen 4 174
- Screen 5 174
- Screen 16 178
- VLAN Configuration Menu 181
- Table 3-12 describes the 182
- Table 3-14 187
- Table 3-15. Reserved PIDs 188
- Port Configuration 195
- Table 3-19 describes the 196
- MultiLink Trunk Configuration 200
- Table 3-21 describes the 201
- Table 3-23 describes the 206
- Port Mirroring Configuration 207
- Table 3-24 describes the 208
- Table 3-25. Monitoring Modes 210
- Rate Limiting Configuration 211
- IGMP Configuration Menu 214
- Table 3-29 describes the 220
- Port Statistics 221
- ATM Configuration Menu 225
- Renumber Stack Units 243
- Hardware Unit Information 245
- Spanning Tree Configuration 245
- Software Download 256
- Download screen 257
- Configuration File 260
- Display Event Log 263
- Excessive Bad Entries 264
- Write Threshold 265
- Flash Update 265
- Save Current Settings 266
- Reset to Default Settings 269
- Chapter 4 273
- Troubleshooting 273
- Interpreting the LEDs 274
- Warning: 276
- Normal Power-Up Sequence 277
- Port Connection Problems 278
- Software Download Error Codes 280
- Appendix A 283
- Technical Specifications 283
- Physical Dimensions 284
- Performance Specifications 284
- Data Rate 285
- Interface Options 285
- Safety Agency Certification 285
- Electromagnetic Emissions 285
- Electromagnetic Immunity 286
- Declaration of Conformity 286
- Appendix B 287
- Media Dependent Adapters 287
- 400-4TX MDA 288
- 100BASE-FX MDAs 289
- 400-2FX MDA 290
- Installing an MDA 292
- Replacing an MDA 293
- Appendix C 295
- Quick Steps to Features 295
- Configuring 802.1Q VLANs 296
- Off-page reference 297
- On-page reference 297
- Configuring MultiLink Trunks 302
- Configuring Port Mirroring 303
- Configuring IGMP Snooping 305
- Appendix D 309
- MDI and MDI-X Devices 310
- Appendix E 315
- Default Settings 315
- Appendix F 323
Relacionado con productos y manuales para Redes Nortel Networks 10BASE-T
Redes Nortel Networks NN43001-321 Manual de usuario
(110 paginas)
(110 paginas)
Redes Nortel Networks 24T Manual de usuario
(310 paginas)
(310 paginas)
Redes Nortel Networks 400-S Manual de usuario
(86 paginas)
(86 paginas)
Redes Nortel Networks 5100 Manual de usuario
(160 paginas)
(160 paginas)
Redes Nortel Networks NN47200-503 Manual de usuario
(318 paginas)
(318 paginas)
Redes Nortel Networks NN46110-602 Manual de usuario
(230 paginas)
(230 paginas)
Redes Nortel Networks CVX 600 Manual de usuario
(168 paginas)
(168 paginas)
Redes Nortel Networks 553-3901-200 Manual de usuario
(48 paginas)
(48 paginas)
Redes Nortel Networks WEB OS 212777 Manual de usuario
(482 paginas)
(482 paginas)
Redes Nortel Networks NN43001-301 Manual de usuario
(306 paginas)
(306 paginas)
Redes Nortel Networks NN43001-314 Manual de usuario
(418 paginas)
(418 paginas)
Redes Nortel Networks 553-3001-358 Manual de usuario
(244 paginas)
(244 paginas)
Redes Nortel Networks NN44200-313 Manual de usuario
(66 paginas)
(66 paginas)
Redes Nortel Networks HotWire 8600 Manual de usuario
(62 paginas)
(62 paginas)
Redes Nortel Networks P0990474 Manual de usuario
(94 paginas)
(94 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.066 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales