Nortel Networks 10BASE-T Manual de usuario descargar pdf (Pagina 33)

Introduction to the BayStack 410-24T Switch

309985-C Rev 00

1-3

The console port default settings are: 9600 baud with eight data bits, one stop bit,

and no parity as the communications format, with flow control set to Xon/Xoff.

Uplink/Expansion ModuleSlot

The Uplink/Expansion Module slot allows you to attach optional media dependent

adapters (MDAs) that support a range of media types (see Appendix B, “

Media

Dependent Adapters” for more information about MDA types available from

Nortel Networks).

10BASE-T Port Connectors

Your BayStack 410-24T switch uses 10BASE-T (8-pin modular) port connectors.

All BayStack 410-24T switches are shipped with port connectors configured as

MDI-X (media-dependent interface-crossover). These ports connect over straight

cables to the network interface controller (NIC) card in a node or server, similar to

a conventional Ethernet repeater hub. If you are connecting to another Ethernet

hub or Ethernet switch, you need a crossover cable unless an MDI connection

exists on the associated port of the attached device (see “MDI and MDI-X

Devices” on page D-2).

Your switch ports support half- and full-duplex mode operation and use RJ-45

port connectors to connect to 10BASE-T Ethernet segments or nodes (see also

“Connecting 10BASE-T Ports and

10/100 MDA Ports” on page 2-8).

See Appendix D, “

Connectors and Pin Assignments,” for more information about

the RJ-45 port connectors.

Note:

The Console/Comm Port is configured as a data communications

equipment (DCE) connector. Ensure that your RS-232 cable pinouts are

configured for DCE connections (see “DB-9 (RS-232-D) Console/Comm Port

Connector” on page D-5).

Note:

10BASE-T/100BASE-TX MDA ports (optional) must use Category 5

UTP cable to accommodate the 100BASE-TX functionality.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 329 330

Sin comentarios

Nortel Networks 10BASE-T Manual de usuario Pagina 33